5/16″ x 50′ L-Shaped Colored Door Edge Guard Molding for Cars and Trucks
Color Trim 5/16″ L-Shaped Door Edge Guard This Door Edge Guard is in a 50 ft. Roll. If you wish to purchase a larger roll, message us and we will send you the listing. Color Coded to match your car’s factory Paint Color; Match your Paint Code to the Above Chart This L Shaped Door Edge Molding can be used in vehicles, furniture, spas, tubs and almost any unfinished edge. It comes with a 3M Acrylic Foam Tape for easy, quick installation. If you are searching for a different molding, size, or color, message us and we will find the right product for you. If you see a color on the color chart that is not listed, it will still be available, we can point you to the correct listing Application Procedures 1. The body of the vehicle must be clean and dry to achieve the best adhesion. Clean with 70% Isopropyl Alcohol. 2. The pressure sensitive adhesive on the molding must not be contaminated during the application. 3. The molding must be applied to achieve complete contact (bond) of the adhesive to the vehicle. (i.e. maximum wet-out) 4. Molding adhesion is best when applied at temperatures above 80 degrees Fahrenheit to 110 degrees Fahrenheit. 5. During cold weather, warm molding with a heat gun or heat lamp. Be careful not to damage the surface. 6. Cut molding with an anvil type cutter to proper length. 7. Allow 24 hours for molding to set. ******It is up to the customer to find the correct color trim for their vehicle. If you are not confident in the color options, message us with your vehicle Make, Year, and Paint Code and we can find the best match for your vehicle!*******
Car Door Bumper Sill Protective Film Carbon Fiber Scratch Guard Strip
This protective film sits right where it matters – on the threshold, the sill, anywhere a door swing or careless hand might leave a mark – and does the job without looking like it’s trying too hard. The finish has a subtle carbon weave look that reads as purposeful rather than patched.